An ISO 9001:2015, ISO 14001:2015, ISO 45001:2018 Certified Manufacturer.

  • Call Us Today

    (+971) 6 5360 116

  • Working Hours

    Mon - Sat: 8 am to 6 pm

  • P.O. Box 78774

    Sharjah - UAE

Ask Experts

CRES®FLOOR EP 300

Solvent based epoxy primer

Two component fluid epoxy resin is designed to penetrate into porous substrate to improve the bonding in flooring and coating products.

Properties:

  • Good penetration to substrate.
  • Excellent adhesion to cement, wood, masonry, screed and steel etc.
  • Good chemical resistance.

Uses:

  • Priming and sealing of substrates before the application of epoxy and polyurethane.
  • General purpose primer for cement and steel surface for CRES range of flooring and coatings.

Packing & Colour:

PackingAppearance
Two packs of 15 L kit.
Component A: Resin
Component B: Hardener		Liquid coating.

Related Document(s):

kanz-horizon-download

How to Use:

  • Substrates: Remove all grease, oil, dust, residual curing compound, mould release agent or other contaminant that could impair adhesion. Laitance should preferably be removed by light sweep blasting or hydro-jetting. Allow the applied material to harden. After all preparation is complete, ensure dust is removed from the surface using an industrial vacuum.
  • For preparation of product, pour component B (hardener) into component A (resin) and mix carefully with electric mixer at low number of turns, till obtaining a homogeneous mix. It is always recommended to mix a complete kit at a time. Over mixing must be avoided to minimize air entrainment. Once mixed, the material must be used within its pot life.
  • Apply the product with a brush or roller or squeegee in its pure state at a rate of 4.0-6.0 m2/L per coat. This rate might vary depending on surface conditions. The primer must be well scrubbed into the substrate to ensure full coverage. A second priming coat may be required if the substrate is particularly porous. Re-prime if the primer coat has not been over coated within 24 hours. Dust and surface contamination must be removed prior to applying subsequent products.

Related Products:

Previous
Next