An DCL & ISO Certified Chemical Manufacturer.
-
Call Us Today
(+971) 6 5360 116
-
Working Hours
Mon - Sat: 8 am to 6 pm
-
P.O. Box 78774
Sharjah | Abu Dhabi - UAE
CRES®BOND EB
Solvent free epoxy bonding agent
Two part solvent free bonding agent composed of liquid epoxy resin and hardener. It is used for bonding of structural concrete new to old concrete and bonding agent for bricks and steel components because it gives excellent bonding properties to freshly mixed concrete/mortars, glazed bricks, tiles etc.
Properties:
- Good adhesion to most building materials.
- Non shrinking.
- Suitable for dry and damp concrete substrate.
- High bond strength.
- Good chemical resistance.
Uses:
- Bonding of old to new concrete/mortar.
- Bonding agent for glazed brick, tiles, steel & structural members.
- Structural adhesive for properly prepared concrete, masonry, metal and wood surfaces.
- Corrosion protection and coating for steel reinforcing bars.
Packing & Colour:
| Packing | Appearance |
|---|---|
| 5 L kit.Component A: Resin. Component B: Hardener | High viscous liquid |
Related Document(s):
How to Use:
- The surface must be thoroughly cleaned and prepared. Remove all loose particles, dirt, dust, laitance and mould release agents, curing compounds, oils, grease, floor hardeners and any waterproofing materials for best results. Remove laitance, dirt and dust by mechanical scarification such as wire brushing, scrapping, scabling or girt blasting.
- Clean the dust by pressurized air or by washing with water. Oil and grease should be removed by degreasing with solvents like turpentine or thinners. Visible signs of mould growth should be removed & treated with a fungicidal solutions. New concrete must be cured properly.
- It is essential that the mixing instructions are carefully followed to ensure the correct characteristics of the product are achieved. Failure to do so can result in lower performance or even possible failure of the product. For preparation of product, properly stir each component A & B separately before mixing together. Pour component B (hardener) into component A (resin) and mix carefully with electric mixer at low number of turns till obtaining a homogeneous mix. It is always recommended to mix a complete kit at a time. Over mixing must be avoided to minimize air entrainment. Once mixed, the material must be used within its pot life.